This brushless gimbal motor controller expands on the capabilities of the BGMC2, adding I2C and analog control, the ability to enable/disable the motor drive, combined speed and precision software for the best of both worlds, and more!
A BGMC, and then some.
This motor controller allows multiple brushless gimbal motors to be controlled in parallel via any RC receiver channel (1-2ms PWM signal), analog voltage (0-5V), or I2C. The BGMC Pro2, with its open "bare board" form factor and mounting holes, is designed to function as an OEM solution for professional installation into your product. Solder tabs are easily accessible, so you can solder only the wires you need, for a clean installation. Additionally, the BGMC Pro2 features an 8-pin Molex Picoblade connector on the backside, for a truly professional installation. An 8-pin Picoblade connector and and wires pigtail is included.
All new I2C control is perfect for those looking to very precisely control and brushless gimbal motor controller. This control method is superior to others, and has a higher resolution without any noise. Also, this control method allows you to enable and disable the motor controller chip, to allow the motor to "coast".
BGMC Pro Features and Specs
- Lightweight PCB-only package
- PWM, analog, or I2C control
- Internal BEC provides 5V/1A max output
- Simple to use
- Controls any size brushless gimbal motor
- 4 LEDs provide a plethora of status information
- Motor can be enabled/disabled through I2C
- Hole dimensions: 38x16mm
- Weight: 16g
- Max motor current: 2.5A
- Power: 8V - 20V (2 - 5s lipo)